FDP EX-CP4L, Руководство по установке, Страница: 86 / 91

Page 86 of 91
Rev. 4.20
Restore of Zone out of service:
N° STEP DESCRIPTION
CHAPTER
1 MENU
Press the command button which refers to “Menu”.
2 ZONE
Select the command “ZONE”.
8.3.1
3 vis./mod.
Select the command “vis./mod.”.
8.3.2
4 SELECT LOOP
Select the loop which belongs to the zone.
8.3.3
5
ZONE ADDRESS
Insert the address of the zone.
8.3.4
6 ZONE INFORMATION
Inside this menu you find all the zone’s
parameters.
8.3.5
7 FUORI SERVIZIO: NO Impostare il campo di “FUORI SERVIZIO” a SI.
8.3.5
Repeat the same procedure for all the other Zones which are in put of service if you want to put them back into
service.
Restore Points out of service:
N° STEP DESCRIPTION
CHAPTER
1 MENU
Press the command in reference to voice “Menu”.
2 POINTS
Select the voice “POINTS”.
7.2.1
3
vis./mod.
Select the voice “vis./mod.”.
7.2.2
4
SELECT LOOP
Select the loop to which the point belongs to.
7.2.3
5 POINT ADDRESS Insert the point’s address.
7.2.4
6
POINT INFORMATION
Inside this menu you find all the point’s
parameters.
7.2.5
7 OUT OF SERVICE: NO
Set up the field command of “OUT OF SERVICE” at
YES.
7.2.5
Repeat the same procedure for all the other Points which are in put of service if you want to put them back into
service.
17.9 RESET of CONTROL PANEL for the DEFAULT SET UP
In the case you require to reset the Control Panel at it’s original set up of Factory Standard; you must follow the
steps below:
1. Reset all points’ database.
2. Restore all default set up.
3. Reset events.
Please NOTE: the fields which carry the name of the points and zones remain unvaried.
Reset Points database:
N° STEP DESCRIPTION
CHAPTER
1
MENU
Press the button in reference to the “Menu”.
2
POINTS
Select the voice “POINTS”.
7.2.1
3
Data base Reset
Select the voice “d.b. reset”.
7.2.2
4
Confirm with ok
Select the “Ok” button to confirm the points’
database reset.
5
Re-start control Panel
Once the reset is confirmed, the control panel
will re-start going into “System Fault” ; press
the “ Restore system Fault” placed on the main
board inside the Panel. If there were Loops in
service, they will be put back into service
automatically – to restore the restore of the
“System Fault” it is not necessary to wait for
the Loop to re-start itself.