FLY-DREAM 6 WWW.FD-RC.COM
4 System Menu
Make sure the throttle stick is at idle (down) and turn on the transmitter. The screen display
version information and after 0.5s it will show the information below:
Press ENTER for long time and enter menu setting interface.
Press ENTER a short time, the ENTER button selects in turn each of the six setting screens
(model choice, channel reverse, dual rate D/R, mixing, battery type and bind).
Note: If the throttle stick is not at idle when the transmitter is turned on, the buzzer will
beep rapidly and the screen will display “CH3_” (to indicate throttle channel). If plug into
imitator, screen display “PPN” at electricity display position. Please reference to “8
Simulator mode.”
4.1 Model Choice
Press the button of ENTER and gets into model choice interface, screen will display as:
4.1A. Use the UP and DOWN buttons to change the model number.
A model name of up to four characters can be entered for each model number by pressing EXIT
and using the UP and DOWN buttons; press EXIT again to move to the next character.
Press the ENTER button to move to the Channel Reverse screen.
4.1B.
If you press “EXIT”, the program into the model name change interface, model name
initials flashing, through the "UP" or "DOWN" key to realize character change, through the
"EXIT" button to switch to the next letter. Model name only has four characters, when switching
to the last character, press "EXIT" button again, model name letters to stop flashing. Program
gets into 4.1 A.
There are 8 models for choosing, model name has 4 letters, they can be the letter or be digital,
still can default. Specific letters atlas as follows, a total of 27 characters (including the default):
Tx voltage
Trim indicators
Model
Tx battery state
Model name
Model
