FCI Home Appliances COGB33062, Инструкция по использованию и уходу

Страница: 5 / 40

Use & Care Manual
Model COGB ENGLISH
5
•
Do not clean the cooktop while it is still hot.
Some cleaners produce noxious fumes when
applied to a hot surface.
CAUTION
DO not allow aluminium foil, plastic, paper or cloth to
come in contact with o hot burner or grate. Do not
allow pans to boil dry.
WARNING
The California Safe Drinking Water and Toxic
Enforcement Act requires the Governor of
California to publish a list of substances known to
the State of California to cause cancer, birth
defects, or other reproductive harm, and requires
businesses to warn of potential exposure to such
substances.
This product contains a chemical known to the
State of California to cause cancer, birth defects,
or other reproductive harm.
This appliance can cause low-level exposure to
some of the substances listed, including benzene,
formaldehyde, carbon monoxide, toluene, and
soot.
Warnings for Gas and Electric Installation
In case of Propane gas installation
The cooktop is ready for use with natural gas. It may
be converted for use with propane gas using the
propane conversion kit supplied with the cooktop.
Be sure the unit being installed is correct for the type
of gas being used.
Refer to the rating plate located on the underside
burner box (see installation instruction).
WARNING
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
CAUTION
•
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
•
For personal safety, this appliance must be
properly grounded.
•
Do not under any circumstances cut or remove
the third (ground) prong from the power cord plug.
CAUTION
When connecting the unit to propane gas, make
certain the propane tank is equipped with its own high
pressure regulator.
In addition, the pressure regulator supplied with the
cooktop must be on the inlet gas pipe of this unit.
In case of electrical failure
If for any reason a gas control knob is turned ON and
there is no electric power to operate the electronic
igniter of the cook top, turn OFF all gas control knobs
and wait 5 minutes for the gas to dissipate before
lighting the burner manually.
To light the burner manually, carefully hold a lighted
match to the burner ports and push and turn the gas
control knob to HI until it lights and then turn the knob
to desired setting.