FBII XL-2T, Руководство пользователя, Страница: 23 / 30

- 23 -
FEDERAL COMMUNICATIONS COMMISSION (FCC)
STATEMENT
This equipment has been tested to FCC requirements and has been found
acceptable for use. The FCC requires the following statement for your
information:
This equipment generates and uses radio frequency energy and if not installed
and used properly, that is, in strict accordance with the manufacturer's
instructions, may cause interference to radio and television reception. It has
been type-tested and found to comply with the limits for a class B computing
device in accordance with the specifications in Subpart J Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference in
a residential installation. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference
to radio or television reception, which can be determined by turning the
equipment on, the user is encouraged to try and correct the interference by one
or more of the following measures:
If using an indoor antenna, have a quality outdoor antenna installed.
Re-orient the receiving antenna until interference is reduced or eliminated.
Move the receiver away from any wire runs to the control/communicator.
Plug the control/communicator into a different outlet so that it and the receiver
are on different branch circuits.
If necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.
The user or installer may find the following booklet prepared by the Federal
Communications Commission helpful: "Interference Handbook." This booklet is
available from the U.S. Government Printing OFFice, Washington, DC 20402.
The user shall not make any changes or modifications to the equipment unless
authorized by the Installation Instructions or User Guide. Unauthorized
changes or modifications could void the user's authority to operate the
equipment.
TELEPHONE OPERATIONAL PROBLEMS
In the event of telephone operational problems, disconnect the control by
removing the plug from the RJ31X wall jack. We recommend that your certified
installer demonstrate disconnecting the phones on installation of the system. Do
not disconnect the phone connection inside the control/communicator. Doing so
will result in the loss of your phone lines. If the regular phone works correctly
after the control/communicator has been disconnected from the phone lines, the
control/communicator has a problem and should be returned for repair. If upon
disconnection of the control/communicator, there is still a problem on the line,
notify the telephone company that it has a problem and request prompt repair