FB Jets T33, Инструкция по сборке, Страница: 10 / 19

FEI BAO/FB Jets Large T33
Photo 3 – Rudder Servo and push rod.
•
Run the servo wire out of the bottom of the vertical stab.
•
Trial fit the phenolic control arm in the slot routed in the rudder at the factory. You may
need to use a small carbide cutter to enlarge the slot slightly for a good fit. Be careful to
NOT route through the other side of the control surface. A small piece of tape wrapped
around the cutter at the proper depth will help prevent a mishap.
•
Roughen the surface of the control arm where it will glue into the rudder with 100 grit
sandpaper.
•
Tape around the slot with masking tape and apply a liberal amount of Aeropoxy or Hysol
into the slot to ensure it is secure but with no glue on your surfaces.
•
Locate lock clamp in the fuse rear section and slide the fin into place while routing the
servo wire through the hole. Tighten the clamp.
•
Install a servo extension of the proper length to reach your receiver and secure the
connection with a large piece of heat shrink or tape.
Photo 4 – additional front screw to the front pin of the vertical stab.