Fayat Group DYNAPAC DRP15X, Оригинальная инструкция по эксплуатации

Страница: 107 / 120

2. Disassemble the drain plug (3) and the seal (4) from the car-
burettor and collect leaking fuel.
3. Disassemble the filter bowl (2) and the O-ring (1).
4. Open the fuel valve and collect running out fuel.
5. Close the fuel valve.
6. Install the drain plug with the seal on the carburettor.
7. Assemble the filter bowl with the O-ring.
8. Dispose of fuel in line with environmental regulations.
Tool: n Spark plug spanner 21 mm
1. Clean the area around the spark plug.
2. Remove the spark plug using the spark plug spanner.
3. Fill in several drops of fresh engine oil through the ignition
plug opening.
4. Crank the engine several times with the recoil starter to dis-
tribute the oil in the cylinder.
5. Screw the spark plug back in.
6. Slowly pull the starter rope until resistance can be felt and
the alignment mark (2) on the starter disc is in line with the
upper bore (1).
ð
Valves are closed so that no moisture can enter into the
cylinder.
7. Slowly guide the starter rope back.
1. After shutting down store the machine under cover in a dry
and well ventilated room.
2. Repair damaged paint; preserve bare areas thoroughly with
anti-corrosive agent.
3. Cover the engine to protect it against dust and moisture.
4. A machine with conserved engine must be clearly marked by
attaching an information sign.
B-834-0045
1
2
3
4
Fig. 143
Protecting the cylinder
B-HON-0048
Fig. 144
2
1
B-834-0035
Fig. 145
Parking the machine
Maintenance – As required
DRP15X 107