FAURE-HERMAN
COMPONENT MAINTENANCE MANUAL
744-082 / 744-082-3
28-49-91
PAGE 701
JULY 17/13
ASSEMBLY AND STORAGE
1.
EQUIPMENT REQUIRED
A.
Tools and equipment
-
3 mm screwdriver.
-
30/40 W soldering iron.
-
8 and 10 mm wrenches.
-
Torque screwdriver capacity of 2 cN.m to 135 cN.m (0.20 lb.in to 12 lb.in) with hexagonal male
adapter.
-
Blower of dry low-pressure compressed air.
-
Hot air generator.
B.
Consumables
-
Cleaning agent KF1019.
2.
ASSEMBLY (See IPL figure 1)
WARNING: STANDARD WORKSHOP PRACTICES MUST BE EMPLOYED THROUGHOUT
THE OPERATIONS AND PRECAUTIONS RELATING TO THE USE OF
MATERIALS AND SUBSTANCES, WHICH MAY BE INJURIOUS TO HEALTH,
MUST BE OBSERVED. PRECAUTIONS REGARDING THE HANDLING OF
ELECTROSTATIC SENSITIVE DEVICES ARE APPLICABLE.
CAUTION: THE WORK SHOULD BE CARRIED OUT IN A CLEAN DUST-FREE
ATMOSPHERE AND THE WORKBENCH, COMPONENTS AND TOOLS MUST
BE KEPT CLEAN.
CAUTION: DO NOT CAUSE DAMAGE TO THE ADJACENT COMPONENTS OR THE WIRING
DURING THE SOLDER WORK. DO NOT APPLY HEAT LONGER THAN
NECESSARY.
ELECTRICAL CONNECTIONS SHOULD BE MADE USING THE MINIMUM
AMOUNT OF SOLDER NECESSARY TO EFFECT AND EFFICIENT JOINT. AFTER
SOLDERING BRUSH THE SOLDERED JOINT AND THE SURROUNDING AREA
WITH THE SPECIFIED CLEANING AGENT TO REMOVE SURPLUS AND
SOLDER PARTICLES. DRY WITH A LOW-PRESSURE AIR JET.
REMOVE THE REMAINING FLUX IMMEDIATELY AFTER THE SOLDER WORK
IS COMPLETED. THE FLUX CAUSES CORROSION AND PREVENTS CORRECT
ADHESION OF THE PROTECTIVE VARNISH.
CAUTION: REPLACE ALL THE LOCK WASHERS REMOVED DURING DISASSEMBLY
WITH NEW ONES.
The document reference is online, please check the correspondence between the online documentation and the printed version.