Version 6
Operating instructions
CCS Silver
Firmware 2021-01-14
Page:
5
of:
72
FAUDI Aviation GmbH, Scharnhorststraße 7 B, D-35260 Stadtallendorf
Manual_CCS_silver_Eng_
operation_version6.docx
1
Foreword
1.1
Purpose
The Contamination Control System has been designed for a continuous evaluating of water
contamination in fuel measured by an AFGUARD® - free water sensor. If water
contamination is too high for a while it interrupts the refuelling process via a safety relay.
Additionally, it can evaluate other sensors like a SLUGGUARD®. The contamination control
system is especially made for guarding a filter water separator or a dirt-defence filter system.
The CCS will also log information on a USB drive for every refuelling cycle.
1.2
Safety instructions
This manual provides operation and routine maintenance instructions for the FAUDI Aviation
Contamination Control System.
Read this manual and ensure that you fully understand its content before you attempt
to install, use or maintain the Contamination Control System.
Work on electrical equipment is to be conducted by trained specialists only, according to
valid regulations.
Attention must be paid to the requirements of VDE 0100 when setting up high-power
electrical units with nominal voltages of up to 1000V, including associated standards and
stipulations.
Check the details on the type plate to ensure that the equipment is connected to the correct
mains voltage.
Protect against touching dangerously high electrical voltages. Before opening the equipment,
it must be switched off and hold no voltages. This also applies to any external control circuits
that are connected.
The equipment is only to be used within the permitted temperature and operation ranges.
Check that the location is weather-protected. It is recommended that the Contamination
Control System should not be exposed to either direct rain or moisture.
Installation, maintenance, monitoring and any repairs may only be conducted by authorized
personnel with respect to the relevant stipulations.
All changes of the standard Contamination Control System with parts which are not specified
or approved by FAUDI Aviation GmbH, as well as repair and service with unspecified parts
will result in loss of the CE conformity and guarantee.
In case of doubt, please turn directly to FAUDI Aviation GmbH, respectively to your FAUDI
Aviation Distributor or Service organization.
1.3
Designated use
The CCS is suitable for indication and measuring operation of the AFGUARD
®
during the flow
of a medium to be monitored (kerosene, diesel, AVGAS, etc..). Its intention is to catch up
electrical signals coming from electrical sensors to detect water content values during flow.
Additionally, hereto it provides the functionality to detect and give out alarm status if high free
water values are detected.
The manufacturer is not liable for damages caused by improper or non-designated use
