BILL ACCEPTOR
Remove the lower block-off plate from the door by removing the four #8 nuts with an 11/32 nut driver and the two
ground wires from the bottom left stud. Install the bill acceptor on the studs then, using the nuts removed above; se-
cure the bill acceptor to the door. After the bill acceptor is mounted, the
two ground wires must be re-installed
to
the stud from which they were removed. Tighten all four nuts to secure the entire assembly, then power up vender
and test for proper operation.
Note: The coin mechanism must be installed with coins in the coin tubes and at least one selection
must be programmed in order to test bill acceptor function. Please refer to the programming section
for more information on how to program vender.
CARD READERS
There are many card readers and similar devices available.
FASTCORP
has tested many of these devices in order
to ensure compatibility with our software. Occasionally, there will be a new product introduced into the market which
may require further testing to ensure correct compatibility. In
most
cases there are no issues so long as the periph-
erals are of level 2 or higher MDB specifications. If you have any difficultly with peripherals that you are using,
please call
FASTCORP
Technical Service.
A card reader can be installed directly above the bill acceptor in the upper most access hole. The access hole will
have a block-off plate preinstalled from the factory and must be removed prior to installation of the card reader. Re-
move the four #8 nuts on the back of the plate using a 11/32 nut driver.
A-8
