5
Part #30161
Revised 8/14/07
FAST™
3400 Democrat Rd.
Memphis, TN 38118
Phone: (901) 260-3278 Fax: (901) 375-3408
www.fuelairspark.com
12.
Connect one end to the outlet of the fuel tank sump and the other end to the fuel pump/filter
assembly inlet and tighten.
Note: It is recommended that a fuel shut off valve be installed between the fuel tank outlet
and the fuel pump & filter assembly inlet, these valves are available from most popular
racing fitting manufactures; Aeroquip, Earl’s, Goodridge, Russell, etc.
13.
In vehicles engine compartment, locate a suitable mounting location for the supplied fuel
pressure regulator.
14.
Starting from the determined regulator mounting location in the engine compartment, plan a
route to run an AN-06 return line back to the fuel tank or fuel cell return port and measure the
required length.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain
components and any exhaust components! Protect fuel lines from abrasion and road
obstructions or debris.
15.
Thread one end of the AN-06 return line onto the AN-06 return line accommodations of your
fuel tank or fuel cell and tighten.
16.
Make any line or electrical adjustments necessary to clear the vehicles exhaust, suspension, and
drivetrain components.
Section 2 – Fuel Regulator Installation and Fuel Line Plumbing
1.
In the vehicle’s engine compartment, mount the supplied fuel pressure regulator in the location
established in step 1 – 15. Using the supplied mounting bracket as a template, mark the bracket
mounting holes and drill to accept a #10 screw.
2.
With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using
two #10 screws, nuts and lock washers (not provided).
3.
Install two of the supplied AN-10 o-rings on the cutoff side of two AN-10 cutoff to AN-08
reducer union fittings, if not already installed, and install in each of the AN-10 ports located on
the sides of the supplied fuel pressure regulator.
