7
Part #30161
Revised 8/14/07
FAST™
3400 Democrat Rd.
Memphis, TN 38118
Phone: (901) 260-3278 Fax: (901) 375-3408
www.fuelairspark.com
8.
Attach the Y-block to the vehicle using two #10 screws, nuts and lock washers.
9.
Install two of the supplied AN-08 o-rings on the cutoff side of two AN-08 cutoff union fittings,
if not already installed, and install in each of the AN-08 ports located on the supplied Y-Block.
Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 to AN-08 reducer
union fitting, if not already installed, and install in the AN-10 port located on the supplied Y-
block.
10.
Starting from the fuel rails, plan a route to run an AN-08 supply line from each fuel rail to each
side of the Y-block.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain
components and any exhaust components! Protect fuel lines from abrasion and road
obstructions or debris.
11.
Using the above steel braided hose assemblies, connect one end to the Y-block and the other
end to the fuel rails and tighten.
12.
Starting from the outlet of the fuel pump/filter assembly; plan a route to run an AN-08 supply
line from fuel pump/filter assembly to the Y-block, this line should be run along the same route
you planned to run the return line in section 1, step 16.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain
components and any exhaust components! Protect fuel lines from abrasion and road
obstructions or debris.
