6
Part #30161
Revised 8/14/07
FAST™
3400 Democrat Rd.
Memphis, TN 38118
Phone: (901) 260-3278 Fax: (901) 375-3408
www.fuelairspark.com
4.
Install one of the supplied AN-06 o-rings on the cutoff side of the AN-06 cutoff union fitting, if
not already installed, and install in the AN-06 port located on the bottom of the supplied fuel
pressure regulator.
5.
Starting from the fuel rails, plan a route to run an AN-08 supply line from each fuel rail to each
side of the regulator. Cut the two supply lines to the determined length and install the AN-08
hose ends, as detailed in Section 3.
Note: Be sure to route all fuel lines clear of any moving suspension or drivetrain
components and any exhaust components! Protect fuel lines from abrasion and road
obstructions or debris.
6.
Using the above steel braided hose assemblies, connect one end to the side of the fuel pressure
regulator and the other end to the fuel rails and tighten.
7.
In the vehicle’s engine compartment, find a suitable mounting location near the fuel rails for
the supplied Y-block, using the Y-block as a template, mark the mounting holes and drill to
accept a #10 screw.
