Fass TITANIUM SIGNATURE TS-F18-125G, Руководство по установке

Страница: 14 / 39

STEP 1:
INSTALL ELECTRICAL HARNESS
www.fassride.com
(866) 769.3747
The installation of the electrical harness is done first, allowing power to be applied to the
pump for lubrication purposes later in the installation.
B. Place wire from ADD-A-CIRCUIT 46177 and WH-1006-3 into butt connector.
Using crimping tool connect ADD-A-CIRCUIT 46177 and WH-1006-3 with butt
connector. Install 46116 to ADD-A-CIRCUIT 46117 bottom slot (near wire that feeds
additional circuit.
A .
Crimp the ring terminals to the red and green wires of the WH-1006-3 Wire
Harness. Attach red wire to the positive terminal of the battery and the green wire to
the negative terminal. Use supplied dielectric grease on all electrical connections.
C . Secure relay and fuse in an upright position, as shown, to prevent moisture from entering. Be sure to
use supplied dielectric grease on relay pigtail.