Fasel Elektronik FCU2000-IR series, Руководство по эксплуатации

Страница: 28 / 44

„Basic settings“ menu
28 Operating manual Series FCU2000/3000/4000-IR B_FCUxxxx-IR / Version V 1.07
1. Press (basic settings) key. The lamp next to the key must light up.
2. Press the key until you see the following view:










Fig. 13: “Light settings" view (example)
3. Press the key.
4. Following view is displayed:
  










Fig. 14: "Light settings – change mode" view (example)
5. Select one of the following lines with the or key:
– Light ON at start

(
→
point 7)
– Light ON if bath ready

(
→
point 11)
– Falling delay time x min

(
→
point 15)
Note!
Only the option "light ON at start" or "light ON if bath ready" can be selected.
6. Press the key. Selected line is enabled.
7. Option "light ON upon starting" is enabled. Cursor flashes on the selected line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).
8. Press the key. The selection is saved.
9. Exit the menu using the key or select the next line with the or key.
10. Press the key. The selected line is enabled.
11. Option "light ON after heat-up phase" is enabled. Cursor flashes on the selected
line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).