6
Revision date: 11.01.19
CARTS AND WAGONS
Parts List and Tools Required
Rear Axle Braces (2)
Rear Axle (1)
Tub Latch (1)
Socket and Ratchet Set
Straight Screwdriver
5/16" x 3/4" (M8) Pan
Head Bolts (10)
5/16" (M8) Locknuts (10)
Flat Washers (10)
4
ATTACH TUB LATCH AND REAR AXLE COMPONENTS
STEP 1:
Position tub on a flat surface.
Insert pan head bolt from the inside and
place latch assembly over bolt. Add washer
and locknut. Align the remaining holes and
repeat to install the three (3) remaining
bolts.
STEP 4:
Remove wheel nuts and washers
from axle ends, slide rear axle braces onto
axle, align holes, and insert a pan head bolt
up through the tub. Add washer and nut.
Repeat to install the remaining bolts.
STEP 2:
Hold the bolt heads with a
screwdriver and slightly tighten nuts.
Do
not fully tighten at this time. Allow latch
to remain loose so it can be adjusted
after installing the front axle and frame
assembly.
STEP 5:
Verify that the axle assembly is
square on the tub and tighten all mounting
bolts using a screwdriver to hold the bolts
and a wrench (or socket and ratchet) to
tighten the nuts. To prevent damage to the
bolts and nuts,
do not overtighten. Bolts
should be snug.
STEP 3:
Place the rear axle on the tub.
Insert two pan head bolts up through the
tub, install washers and nuts, and slightly
tighten.
Do not fully tighten until completing
the Step 5.
Photo above shows cart tub and the
attached tub latch, rear axle, and rear
axle braces.
