8
Revision date: 11.01.19
CARTS AND WAGONS
Parts List and Tools Required
STEP 1:
Remove wheel locknut and washer
from axle and slide wheel onto axle.
STEP 4:
Determine the desired handle
orientation, slide coupler onto end of the
handle, and align bolt holes.
STEP 2:
Ensure valve stem is to the
outside and add washer and locknut.
STEP 5:
Insert the long hex head bolt
through the yoke, coupler, and handle
mounting holes.
STEP 3:
Tighten locknut. Repeat these
steps for the remaining wheels.
STEP 6:
Add the washer and locknut.
6
INSTALL WHEELS AND TUB HANDLE
Socket and Ratchet Set
5/16" x 2 1/4" (M8)
Hex Head Bolt (1)
Washer & Locknut
(1 each)
Handle (1)
Coupler (1)
Wheels (4)
STEP 7:
Tighten the nut until snug and
then back nut off 1/4 to 1/2 turn to allow
handle to move freely at the joint.
*Axle locknuts and flat washers are typically shipped from the factory attached to the front and rear axles.
Wrench
