Farmi Forest Mastersplit WP30, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 20 / 68

MASTERSPLIT WP30
20
SPLITTING MACHINE OPERATION
This part of the operating manual explains the adjust-
ments for machine operation and the correct working
procedures.
SPLITTING MACHINE OPERATION ADJUSTMENTS
• adjustment of the split wood length
• adjustment of the splitting blade height
• Adjustment of the operating position of the con-
veyor
• Conveyor belt adjustment
ADJUSTMENT OF THE LENGTH OF SPLIT WOOD
(see figures below)
• adjustment of the split wood length is achieved by
moving the stopper plate
• Open the locking screw of the stopper plate shaft.
• Move the stopper plate until it has reached the re-
quired position on the scale.
• Tighten the locking screw securely.
CAUTION!
!
SPECIFICATIONS OF THE UNIVERSAL SHAFT
LENGTH (Mastersplit TR)
• Disconnect the universal joint halves from each
another.
• Connect one half of the universal shaft to the trac-
tor, and the other half to the splitting machine.
• Raise the splitting machine from the ground so
that the shafts’ ends are as close together as pos-
sible.
• Mark the shafts with the contraction points and
leave a safety margin of approx. 30 mm (maintain
the shaft’s length ratio and the cover the same!)
NOTE! The use of a universal shaft that is too
long may damage the machine.
• WARNING! Exercise extreme caution as you may
get crushed when working between the wood
splitting machine and the tractor.
CHAINSAW LUBRICATION CONTROL
Do not switch the splitting machine on until the follo-
wing procedure has been completed.
• Hold the operating lever and make a few sawing
maneuvers until some oil drips from the chainsaw.
(Note! Complete this procedure every time you
begin to work with the splitting machine!)
• If oil does not drip, check the adjustment of the
lubrication system. (See section: ”Troubleshoo-
ting”).