Manual
VIDIUM P 350 | P 450
19
│
24
5.3.6
Setting the Plough Angle
The angle of the wheel is set using the setting spindle (Pos. 1)
separately on the left and on the right so that the equipment
or the plough shaft (Pos. 2) is vertically to the ground. To
turn the setting spindle, it is required to shortly compress the
rotary cylinder.
The angle is set by the tilting mechanism in the front and at
the axle in the rear.
OnLand Version:
The setting spindles are turned all the way down in the
OnLand Version (x= approx. 1cm)
5.3.7
Precise Adjustment of the Spacing
(For models without the OnLand version)
According to the depth of ploughing and the setting of the wheel angle, the work coverage of the first bod y S1 is
adjusted using the support X guidance with the setting cylinder so that it corresponds with the appropriate work
coverage of the rear body S.
In OnLand models that are set to the furrow operation, this setting is performed using the perforated bar.
The size of all other settings is influenced by each setting adjustment and therefore they must be also adjusted.
