Manual
VIDIUM P 350 | P 450
15
│
24
5.2
PREPARATION OF THE PLOUGH
Lubrication:
Protective Coating
Lubricate all lubricating points
Remove the protective coating from
According to the Lubrication Plan (Chapter 8)
the ploughshares
5.3
SETTING THE PLOUGH
IN GENERAL
When the plough is used for the first time, we recommend to perform general setting in the yard. After that, only
minor setting corrections are required in the field provided that the recommendations are observed. Execute the
settings only when the plough is aggregated with the tractor!
5.3.1
Setting the Work Coverage Width
There are four possible work coverages for VIDIUM P350 and P450: 36 cm, 40 cm, 44cm and 48 cm
a)
Loosen the front bolt of the plough shaft carrier
(Pos. 1)
b)
Remove the rear bolt of the plough shaft carrier
(Pos. 2)
c)
Tilt the plough shaft carrier (Pos. 3 so that the
required opening of the plough shaft carrier is located
in the frame tube
d)
Install the bolt back (8 Pos. 2)
e)
Tighten the bolts (Pos. 1 and 2)
When setting the work coverage width, tilt the tools such as fertilizer back-filler, disk coulter and supporting
wheel – if available – separately and adjust them precisely to the new work coverage width. No other resetting or
adjustments are necessary.
