Manual
TURBULENT 3 | TURBULENT 5 | TURBULENT 6
16
│
27
Transport axle
Adjustment plate
with a scale
- transport axle
Axle lifting
piston rod
Rear tyre rollers
Adjustment plate with a scale
- rest tyre rollers, side frames
Turbulent 5; 6
Angle discs
Adjustment plate with a scale
- rest tyre rollers, middle frame
Turbulent 3; 5; 6
5.1.4
Processing depth setting at tyre rollers
Lift the machine on the axle; this will release the stoppers for depth setting of the pneumatic rollers.
The setting of the soil processing depth is performed with the tyre roller using the adjustment plates and
securing pivots, identical depth setting with other mechanisms of the machine is secured by the gauge with a
scale of 1-10.
5.1.5
Angle disc processing depth adjustment
The purpose of the angle discs is to straighten and direct soil after the share section.
First set the working depth of the shares and then set the height position of the angle discs.
Set the depth of soil processing by the angle discs hydraulically (green and black marking of the hoses).
For proper function of the hydraulic control of the discs, it is necessary to set the full flow of oil at the
distributor of the tractor; this will ensure an even shift of the individual sections of the discs.
Move the lever of the distributor section of the tractor to the utmost position when changing the position of
discs.
In case of uneven setting of the depth of the individual sections of discs do the following: stop the tractor
with the machine, lower the discs into the soil; this will ensure the alignment of the depth of the discs.
The height setting of the angle discs is changed according to the soil conditions, working depth, and the
amount of post-harvest remnants.
The suitability of the angle disc setting needs to be practically tested.
Adjustment plate with a
scale of 1 to 10
Depth setting pivot
Transport axle
Adjustment plate with a
scale of 1 to 10
Depth setting pivot
