Manual
TURBULENT 3 | TURBULENT 5 | TURBULENT 6
15
│
27
5.1
MACHINE WORKING DEPTH ADJUSTMENT
5.1.1
Using tractor TPS arms
5.1.2
Using copying wheel locks on side frames
5.1.3
Using transport axle locks
5.1.4
Using tyre roller locks
5.1.5
Hydraulic setting of the angle discs
5.1.6
Using support screws of side frames
5.1.7
Tyre roller processing plane setting
5.1.8
Taking rear additional rollers out of service
5.1.1
Machine adjustment using tractor's TPS arms
Using the tractor's TPS arms, set the machine into a plane with the soil, which will guarantee the same
depth of soil processing in the front and rear part of the machine.
5.1.2
Machine adjustment using copying wheels of side frames
Setting the depth using the copying axle is performed using a pivot that is set in the holes of the copying wheel
adjustment plate.
5.1.3
Processing depth setting at the transport axle
Lower the machine to the shares (the piston rod for lifting the axle must be completely tugged in) to release
the stopper for depth setting. Then you can change the position of the stopper as required.
The setting of the soil processing depth is performed with the transport axle using adjustment boards and
securing pivots, identical depth setting with other mechanisms of the machine is secured by the gauge with
a scale of 1-10.
Tractor's TPS arms
Soil
Machine frame parallel with soil
Depth setting using a
transport axle and rear
rollers
Depth setting using
copying wheels
Adjustment plate
with a scale of 1 to 10
Depth setting pivot
