Manual
FANTOM CLASSIC FX 650 PS | FX 850 PS
42
│ 48
7.
MACHINE MAINTENANCE AND REPAIRS
Observe the safety instructions for treatment and maintenance.
▪
If it is necessary to weld during the repair and have the machine connected to the tractor, it must have
disconnected supply cables from the alternator and the accumulator.
▪
Check the tightening of all screw and other assembly connections at the machine before every use of the
machine, furthermore continuously as needed.
▪
Continuously check the wear of the working bodies of the machine, possibly replace these worn working
bodies with new ones.
▪
Adjustment, cleaning, and lubrication of the machine may only be performed with the machine at rest (i.e.
the machine is standing and not working).
▪
When working on a lifted machine, use suitable support equipment supported at marked points or at points
suitable for that.
▪
During adjustment, cleaning, maintenance, and repair of the machine, you must secure those parts of the
machine that could endanger the operator by falling or another movement.
▪
For catching the machine during handling using lifting equipment, use only the places marked with self-
adhesive labels with the chain sign "
".
▪
Upon a failure or damage of the machine, immediately turn off the tractor's engine and secure against
restarting, secure the machine against movement
only then you can remove the failure.
▪
During repairs of the machine, use exclusively the genuine spare parts, suitable tools and protective
equipment.
▪
Regularly check the prescribed pressure in the machine tyres and the condition of the tyres. Perform possible
repairs of the tyres in an expert workshop.
▪
Keep the machine clean.
Do not clean hydraulic cylinders and bearings with a high-pressure cleaner or direct water
stream. The seals and bearings are not watertight at high pressure.
Never open or adjust (welding, drilling etc.) the pressure vessel (pressure accumulator). The pressure vessel is
still under gas pressure even after it has been emptied.
Empty the pressure vessel in case of any work on the hydraulics of the machine. The manometer must not
show any pressure, or the pressure on the manometer must decrease to 0 bars. Only then it is permitted to
work on the hydraulic circuit.
Nut tightening check
•
Wheel nuts the first time and every time after dismounting wheels
–
after 10 hours
•
Then every 6 months
•
Towing lug nut tightening
–
first after 10 hours and then every 6 months
Brake adjustment
•
The brake lever step must be adjusted before the season to ensure correct braking function
•
The correct brake lever step is 25
–
45 mm
•
When the brake is released, the lining must not rub against the brake drum (check by lifting the wheel)
