Manual
FANTOM CLASSIC FX 650 PS | FX 850 PS
31
│ 48
➢
The end stops below the folding joints must never touch the right and left side frame at the same time.
Only the right or the left wing of the side frame can be touching. These are end stop positions that
ensure the side frame is in the same plane as the central frame.
➢
Prior to setting the end stops, the machine plane must be set using the eye on the folding piston rods.
The side frames are slightly sagging when the machine is lifted on the axle.
➢
The allowance between the end stop and the side frame must be 1
–
3 mm on each side. The
measurement is taken with the machine folded and with fully drawn-out piston rods on the central
frame. See Fig. 8.
➢
The end stops are set when the machine is folded, with the washers to set the allowance added
gradually, see Fig. 7.
➢
The last thing to be set is the top end stops of folding, located below the piston rods that secure the
frames during transport. The initial position is 10 cm from the head of the screw to the central frame
plate.
➢
When folded, there must be no allowance between the top end stops and the side frame. The frames
must always be tight to ensure the proper function of the side frame protection during transport. See
Fig. 9.
Fig. 9
–
Top end stops of folded side frames for the transport position
–
FX650PS (initial position at 10 cm)
3.4.3.2
FX850PS
–
4 PISTON RODS
The machine is folded by four piston rods anchored to the central frame. The machine does not need
bottom end stops because each side frame has its own folding piston rods. The machine plane is set using
the piston rod eye.
