FarmChem APX Industrial DCM-01, Руководство пользователя

Страница: 2 / 12

FarmChem | www.FarmChem.com
2
GENERAL SAFETY REGULATIONS
EQUIPMENT MISUSE HAZARD
• This equipment is for professional use only
• Read all instruction manuals, tags, and labels before operating the equipment
• Use the equipment only for its intended purpose. If you are not sure, call your
distributor
• Do not alter or modify the equipment
• Check equipment daily. Repair or replace wornor damaged parts immediate-
ly
• Do not exceed the maximum workng pressure of the lowest rated system
component. This equipment has a 1500psi (10Mpa, 100bar) maximum working
pressure
• Use fluids and solvents which are compatible with the equipment wetted parts.
Refer to the Technical Data section of all equipment manuals. Read the fluid
and solvent manufacturer’s warnings
• Route hose away from traffic areas, sharp edges, moving parts, and hot sur -
faces
• Do not lift pressurized equipment
• Comply with all local, state and national fire, electrical and safety regulations
INJECTION HAZARD
Spray from the valve, leaks or ruptured components can inject fluid into your body
and cause serious injury, including the need for amputation. Fluid splashed in the
eyes or on the skin can also cause serious injury.
• Fluid injection into the skin might look like just a cut, but it is a serious injury. Get
immediate medical attention
• Do not point the valve at anyone or at any part of the body
• Do not put your hand or fingers over the grease fitting coupler
• Do not stop or deflect leaks with your hand, body, glove or rag
• Tighten all fluid connections before operating the equipment
• Check the hose, tubes, and couplings daily. Replace worn or damaged parts
immediately. Do not repair high pressure couplings; you must replace the
entire hose
WARNING: The warnings, cautions, and instructions discussed
in this instruction manual cannot cover all possible conditions or
situations that could occur. It must be understood by the operator
that common sense and caution are factors that cannot be built
into this product, but must be supplied by the operator.