FAR KJ 60, Оригинальная инструкция по эксплуатации

Страница: 8 / 19

GB
INSTRUCTIONS FOR USE
INDEX
GUARANTEE AND TECHNICAL ASSISTANCE
........
9
SAFETY MEASURES AND REQUIREMENTS .
.........
9
TOOL IDENTIFICATION
...............................
10
GENERAL NOTES AND USE
..........................
10
MAIN COMPONENTS
..................................
10
TECHNICAL DATA
.....................................
10
PLACING OF THE INSERT
............................
11
CHANGE OF SIZE
.....................................
12
TOOPING UP THE OIL-DYNAMIC CIRCUIT
...........
13
DISPOSAL OF THE RIVETING TOOL
.................
13
GUARANTEE AND TECHNICAL ASSISTANCE
FAR riveting tools are covered by a 12-month warranty. The
tool warranty period starts on the date of delivery to the buyer,
as specified in the relevant document. The warranty covers
the user/buyer provided that the tool is purchased through an
authorized dealer and only if it is used for the purposes for
which it was conceived. The warranty shall not be valid if the
tool is not used or maintained as specified in the instruction
and maintenance handbook. In the event of defects or failures,
FAR S.r.l. shall undertake solely to repair and/or replace the
components it judges to be faulty.
SAFETY MEASURES AND REQUIREMENTS
CAUTION!!!
All the operations must be done in conformity
with the safety requirements, in order to avoid
any consequence for your and other people
security and to allow the best tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact
FAR s.r.l.
authorized service centers and use only original spare
parts . FAR s.r.l. may not be held liable for damages from
defective parts caused by failure to observe what
mentioned above ( EEC directive 85/374 ).
The list of the service centres is available on
our website http://www.far.bo.it ( Organization )
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when
using the tool.
• For topping up the oil, we suggest using only fluids in
accordance with the features specified in this working book.
• If any drop of oil touches your skin, you must wash with
water and alkaline soap.
• The tool can be carried and we suggest putting it into its
box after using.
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the tool is
not fed.
• A safety balancer is suggested when it is possible.
• If the A-weighted emission sound pressure level is more than 70
dB (A), you must use some hearing protections (anti-noise
headset, etc.).
• The workbench and the work surface must be always clean and
tidy. The untidy can cause damages to people.
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have the
correct size to be used.
• Do not carry the connected tool by pulling the hose. The hole
must be far from any heating sources or from cutting parts.
• Keep the tools in good conditions; do not remove either safety
parts or silencers.
• After repairing and/or adjusting, make sure you have already
removed the adjusting spanners.
• Before disconnecting the compressed air hose from the tool
make sure that there is no pressure in the hose.
• These instructions must be carefully followed.
WARNING! Before using the tool, assemble the
protection bottom supplied with the tool, as
indicated in the picture on side.
FAR has no responsibility for any damages on the tool,
persons or things caused by lack of the protection bottom.
KJ 60
Revisione - 18 Date 01-2012 7