Fantic Motor TZ 125 2011, Руководство пользователя

Страница: 59 / 72

59
Screen options
The multifunction display shows all the information on three di ff erent screens.
While in motion, screens 1 and 2 are on display. Screen 3 is displayed for 3
seconds, and then returns to screen 1.
To change from one screen to another, press button 2 (“Mode”) in succession.
To edit the distance travelled (DST), keep button 3 pressed down.
Screen 1:
Screen 1 shows the following information:
- Speed, distance travelled, time, ambient temperature.
Screen 2:
Screen 2 shows the following information:
- Speed, time in motion, time in operation, engine temperature*.
Screen 3:
Screen 3 shows the following information:
- Maximum speed, accumulated time in operation, odometer, maximum
temperature*.
(*) Optional
Lighting
The display is powered by an internal 3 V battery, type CR2032.
To change the battery, open the cover behind the display, and use a coin to
unscrew it counter-clockwise. Make sure that the positive terminal on the bat-
tery is facing upward.
When the display is powered by the internal battery only, the screen lights up
partially for 3 seconds when the button is pressed.
If the lighting is connected to the 12V system on the vehicle, it will be brighter
and stay on for up to 20 minutes after the vehicle has come to a full halt.
Sleep Mode
If the multifunction display does not receive any information for 20 minutes
(signal from wheels turning or a button pressed), the screen goes o ff , show-
ing only the time. When the vehicle starts or a button is pressed, it will start
up again.
Measuring the wheel circumference
Method 1
Measures the diameter of the front wheel. Multiply the diameter by 3.14 and,
if necessary, convert the measurement into mm by multiplying the fi gure ob-
tained by 25.4. The measurement obtained is the size of the wheel circumfer-
ence.
Method 2
On a smooth, fl at surface, make a mark on the side of the tyre where it touches
the ground. Move the vehicle forward until the tyre has made a complete turn,
and the mark is back at the lowest point. Make a new mark on the ground at
this point.
Measure the distance between the marks on the ground and, if necessary,
convert the measurement into mm by multiplying the fi gure obtained by
25.4. The measurement obtained is the size of the wheel circumference.
To obtain a more precise measurement, the driver must remain on the vehicle
while taking measurements.