Fantech MUAS 1600, Руководство по установке

Страница: 2 / 16

2
fantech
Note Warning /
Important
note
Information Technical
information
Practical tip
Warnings
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
1. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with national electric codes, local electric
codes, ordinances and regulations, including fire-rated construction
codes and standards.
2. This system is not designed to provide combustion air for fuel-
burning appliances.
3. Do not connect the system directly to a combustion appliance of any
type.
4. Before servicing or cleaning any system component, switch power off
at service panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
5. When performing installation, servicing or cleaning of the system, it
is recommended to wear safety glasses and gloves.
6. Locate the outside air inlet hood above any anticipated snow drift
level and away from any architectural and landscape features to
ensure that the intake area for the outside air duct is not blocked and
provides a clear pathway for outside air to enter the system.
7. When cutting or drilling into wall or ceiling, do not damage electrical
wiring or other hidden utilities.
8. When notching or drilling into framing including floor supports, rim
joists, and wall studs, comply with code and manufacturer limitations
on allowable modifications to these structural members.
9. This system can only be used for its intended design. Any internal
wiring changes, modifications or bypass of any controls, or
installation practices not according to the details of the instruction
manual will void the product warranty. Follow all installation, wiring
and setup instructions indicated in the manufacturer’s manual.
Caution
1. Do not locate outside air inlet near hazardous materials or
explosives.
2. System shall not be installed to introduce air from crawlspaces,
garages, attics, adjacent dwelling units, or other locations within the
building shell. System shall be installed to introduce air directly from
outdoors.
3. Do not install the makeup air system and supply ductwork directly
above or closer than a distance of two feet to any furnace or its
supply plenum, boiler, or other heat producing appliance.
4. Any ductwork used in conjunction with the system must be installed
in compliance with all local and national codes that are applicable.
5. Do not operate the system until all system filters have been installed
per the system design.
6. Please read the specification label on each system component for
further information and requirements.
7. Each system component, including filters, should be inspected and
maintained on a regular basis.
8. This system is intended for installation in a dry location protected
from moisture.
9. This system must be installed in an accessible location which allows
for system inspection and maintenance.
10. This system will automatically provide outdoor air into a building.
Coordinate with the HVAC designer/contractor the effects that the
supply of outdoor air will have on the building’s comfort and
mechanical systems. The HVAC designer should take into
consideration the makeup air system's frequency and duration of
use as well as the outdoor air flow quantity.
11. Use this system only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer at the address or
telephone number provided in this document.
12. When federal, provincial or state legislation comprises more
restrictive installation and/or certification requirements, the
aforementioned requirements prevail over those of this document
and the installer agrees to conform to these at his own expense.
13. Do not supply outdoor air to a space or duct system where water
pipes or water coils might be susceptible to freezing due to the
supply of outdoor air.