EN_FANOXTD_GUIDE_SIL_OCEFPrimaryDist_SILA_R002.doc 5 / 36
1.3.1. Keypad & LCD
•
Use KEYPAD to ensure that all the
push-buttons work correctly (no
difficulties while pushing them,
check out if the relay reacts by
pushing each of the buttons)
•
Use KEYPAD to enter in the relay´s menu and make sure that no text is lost while going
from one menu to another.
•
Follow the sequence: Left ◄, Down
▼, Right ►, Up ▲, OK, C and
RESET and the following screen
should be displayed:
•
If the contrast of the LCD is ot the
correct one
, enter to “CONTRAST”
menu by
holding “◄” for 3 seconds.
Then, change it by using up and
dwon buttons to increase or
decrease the contrast.
1.3.2. Test menu
NOTE:
When performing test menu, protection won´t be available and it will be possible to open
circuit breaker. Only authorized personnel can do this job.
Press ◄,▼,► sequentially and hold OK. The relay will ask for the password “5555” to enter to
the test menu (or customer password if default “5555” has been modified).
LEDs and outputs will be checked to verify
the hardware is OK:
For adaptation C, all LEDs are turned on
when Test Menu is active. Just Outputs can
be activated/deactivated.
For adaptation B, LEDs and Outputs can be
activated/deactivated.
Adaptation C:
Action
Checking
▼
,
OK
Output 1
Output 1 activated
▼
,
OK
Output 2
Output 2 activated
▼
,
OK
Output 3
Output 3 activated
▼
,
OK
Output 4
Output 4 activated
C
Skip from test menu