Fanelite 100YFT-200 TIGA, Руководство пользователя, инструкция по установке и эксплуатации

Страница: 34 / 36

32
The ceiling fan (motor) starts and then stops after few seconds :
This is a safety mode of the receiver because the blades are not installed. Install the blades before using your
ceiling fan.
The ceiling fan no longer works :
1. Check the batteries status of your remote control. Change the batteries if necessary and your ceiling fan
will re-operate normally.
2. Check that the 3 wires and metal pins (pink / grey / red) of the connectors are properly engaged in the con-
nectors. If a wire is badly inserted in the connector, the receiver reacts by an error code. Push on the wires if
necessary to fully engage them in the connector.
3. If, despite the changed batteries, your ceiling fan still does not work, check the condition of the circuit
breakers. If the ceiling fan circuit breaker is OFF, put it back to ON. If the circuit breaker trips OFF again, do
not touch it, leave the power off, and call a qualified electrician.
4. The remote control and the receiver are maybe unpaired. Refer to the USE OF THE REMOTE CONTROL
section to perform the pairing procedure again.
5. If your receiver beeps several times when you press a button on the remote control, this is an error code
and this means that your receiver has locked out. To reset it, turn off the power of your ceiling fan by using
the circuit breaker or switch, wait 1 minute and then turn on the power again.
6. Check your electrical connections. Refer to the ELECTRICAL CONNECTIONS section. Check that all met-
al wires and pins are securely engaged in their connectors. Check that current is coming through your ceiling
AC power supply. Check that no electrical wires are damaged.
The ceiling fan oscillates abnormally during operation :
A ceiling fan vibrates naturally when it is working. Even a well-balanced ceiling fan causes vibration when it
works.
1. Check the condition of the screws of the blades and tighten them if necessary.
2. Check that the hanger ball is securely locked in the hanger bracket (concave groove of hanger ball into the
lugs of hanger bracket).
3. If your ceiling fan still oscillates abnormally when it is working, it may be because the blades are not well
balanced. In this case, use the balancing kit supplied with your ceiling fan to re-balance them. To identify the
defective blade, turn off your ceiling fan, put the plastic pliers on the edge of a blade and turn on your ceiling
fan. Repeat by changing position and blade if necessary until normal operation of the ceiling fan is resumed.
Once the correct position is found, glue the weight at the level of the pliers (onto the blade) then remove the
pliers.
For more information, visit our website www.fanelite.com or contact us. See ADDITIONAL INFORMA-
TION section.
17. TECHNICAL SPECIFICATIONS
Reference : 100YFT-200 TIGA
Power source : 100-240 V~ 50/60 Hz
Protection class : I
Package dimensions 1 : 125 x 23 x 18,5 cm
Gross weight 1 : 12,00 kg