10
When the main unit is on the base station, short press the
" " button on the handle, the self-clean mode indicator
is light up, the main unit will enter the self-clean process
and start cleaning the roller brush. After cleaning the roller
brush, it will automatically start the air-drying process.
Self-clean process: spray water first, and then the roller
brush will rotate and stopping intermittently for self-clean.
After this cycle operation, it will perform a rapid water-
throwing operation and finally enter the air-drying state.
Lastly, the roller brush will run slowly until the self-clean
process is completed.
During the self-clean process, short press the " "
button. The self-clean will stop immediately. If you short
press " " button again, the main unit will re-start the
self-clean process from the beginning.
After the self-clean process is completed, the appliance
will automatically shut down within 5 minutes after the
battery is fully charged and without any operation.
USE OF PRODUCT
Note :
1.
Pour out the sewage from the dirty water tank and fill the water in the clean water tank
before staring the self-clean process.
2.
If the dirty water tank is full and front tank alert is flashing in the process, pour out the
sewage from dirty water tank and ensure that the tank is empty and re-installed properly.
The self-clean process will continue.
3.
If the clean water tank is empty or Rear tank is flashing in the process, refill the water to
clean water tank and ensure that the tank is not exceed the recommend “water level” line,
and also ensure that the tank is re-installed properly. Short press "
" button again,
the self-clean process will continue.
11
\
2.6 Removing and Filling of Clean Water Tank
Disassembly:
Hold the main unit with one hand, press the release button
of the clean water tank with the thumb of the other hand,
and take out the clean water tank.
Filling water (or adding detergent if request):
Flip open the top cover of the clean water tank and pour in
water. For deep cleaning purposes, pour an appropriate
amount of detergent into the water tank to dilute it, and
shake it evenly before use
Installation:
Hold the main unit with one hand and hold the upper sides
of the clean water tank with the other hand. Align the
bottom of the clean water tank with the support position of
the main unit and push inwards. After you hear a "click",
the installation is successful.
2.7 Removing and Empty Dirty Water Tank
Disassembly:
Hold the main unit with one hand and press the dirty water
tank release key with the other hand while pulling out the
water tank outwards.
Take out the filter and top cover in an upwards direction
pour out the sewage.
Installation:
Reinstall the upper cover of the dirty water tank first, and
then install the filter.
Hold the main unit with one hand and hold the dirty water
tank with the other hand. Align the bottom of the dirty water
tank with the support position of the main unit and push
inwards. After you hear a "click", the installation is
successful.
USE OF PRODUCT
