FALMEC NUVOLA, Инструкция пользователя

Страница: 26 / 72

24
the red LED lights up, press any of the radio control’s buttons within 10 seconds. With this
operation a new transmission code is registered.
METALLIC FILTERS AND CARBON FILTER
H
1. METAL FILTERS
To access the metallic filters open the AP panel (see fig. 1). To remove the grease-trapping
metallic filter pull on the handle.
2. CHARCOAL FILTERS
Hood not designed for charcoal filters.
LIGHTING
ASSEMBLY AND REPLACEMENT
I
FLUORESCENT TUBE
(Section reserved for qualified installers)
Replacing the fluorescent tube (fig. 8):
a) Disconnect the device from the mains;
b) Unscrew the fixing screws and remove the bottom panel;
c) Remove the fluorescent tube, by rotating through 90°, and replace it with one of similar
features;
d) Reconnect the device to the mains.
MAINTENANCE AND CLEANING
L
Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
Hood not designed for charcoal filters.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid
that oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using
clean with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain
abrasive substances, rough cloths or cloths specifically designed for cleaning steel. Using