Locating Pins
Fixing screw with washers
B
B
B
B
A
A
A
A
B
B
General Purpose Ovens
Free-standing oven, proceed as 1, 2, 7.
Two Tier
The lower tier oven has adjustable feet. Lift the top
tier on to the lower unit and locate the two front feet
over the raised bosses on the lower unit top plate.
Attach the flue upstand to outer back of both ovens.
Figure 3
2.1.1 Multiple Units
The basic method of joining multiple units consists of
tie plates, bolts and flue collars. Specific procedures
are detailed under ASSEMBLY PROCEDURES.
Figure 4
Outer Panels
When units are suited together, the adjoining outer
side panels should be removed,
e.g. in the eight model suite shown in Figure 4,
there would only be outer panels at A.
Infill strips must be located at B on joined units to
create a finished line in the absence of outer panels.
Components Supplied
Each appliance is supplied complete with a tie plate
secured to the rear underside of the hob.
An additional tie plate is also require at the front.
Service Void
End Panels
S e r v i c e v o i d e n d
p a n e l s m a y b e
supplied. These clip
below the hobs and
are fixed at the bottom.
One service void end
p a n e l n o r m a l l y
contains two holes
which accommodate
the header pipes.
See Figure 5.
Gas Governors
An adjustable gas governor is supplied with each
natural gas model.
Service Cocks
A service cock must be provided on the installation.
Arrangement should be such as to allow one such
device for each half of a central suite to allow
servicing without closing down the whole suite.
Floor Fixing
Each foot has a drilled hole for floor fixing if required.
Assembly Procedure (Central Suites)
Unpack units and refer tothe suite installation plan.
a) Position and level the first unit, commencing at one
corner of the suite.
b) Move the second unit into position at the side of the
first and level off.
c) Remove the cast flues by undoing 4 fixings.
d) Remove the adjoining unit corner post by removing
the knobs and the fixings which project up through
each base into the corner post. Remove the post
by pulling out the bottom end to clear the base and
lower.
e) Ensure hobs are flush. Adjust legs as necessary.
f ) Remove a tie plate from the rear hob underside.
Loosen the other tieplate and rotate through 180
o
.
Secure to the adjacent hob using the screw from
the first plate -see Figure 6.
N.B.- Half the plate will now project from the
hob joint rear.
Tie plate at rear corner
Figure 6
Figure 7
Figure 5
