Model
kW
Btu/hr
G1006X O/T
40
136,400
G1006X S/T
20
68,200
G1026X O/T
30
102,300
G1026X S/T
10
34,100
G1060X O/T
45
153,500
G1006X T/B
24
81,800
G1016/1
10
34,100
G1016/2
20
68,200
G1066X O/T
55
187,600
G1029X O/T
15
51,200
Configuration
Open Top
Oven
Solid Top
Twin Bullseye
kW
Btu/hr
7.5
25,600
10
34,100
10
34,100
7
23,900
Model
kW
Btu/hr
G1006X O/T
28.8
98,300
G1006X S/T
17.5
59,700
G1026X O/T
18.8
64,100
G1026X S/T
7.5
25,600
G1060X O/T
28.2
96,200
G1006X T/B
22
75,100
G1016/1
10
34,100
G1016/2
20
68,200
G1066X O/T
38.8
130,300
G1029X O/T
9.4
32,100
Configuration
Open Top
Oven
Solid Top
Twin Bullseye
kW
Btu/hr
4.7
16,000
10
34,000
7.5
25,600
6
20,500
Configuration
Open Top
Oven
Solid Top
Twin Bullseye
Oven
SIT No. 36 SIT No. 19
Twin Bullseye
30
31
P I L O T B U R N E R S
Natural Gas Propane Gas
Amal 230
Amal 128
é 2.6mm
Amal 360
20 x L69
20 x L80
20 x L69
20 x L76
mbar
inches w.g.
6
14.8
15
37
Natural
Propane
1.7 TOTAL RATED HEAT INPUTS -
NATURAL GAS
INDIVIDUAL BURNER HEAT INPUTS -
NATURAL GAS
1.8 TOTAL RATED HEAT INPUTS -
PROPANE GAS
INDIVIDUAL BURNER HEAT INPUTS -
PROPANE GAS
1.9 INJECTOR SIZES - Natural and Propane Gas
1.10 GAS PRESSURE
A test point is located upon the manifold, behind the
control panel. Solid top, single and double tier oven
model access is gained by removing the panel as
described in Section 3. Access on open top models is
gained by removing the gas tap protection panels
inside the hob aperture.
An adjustable governor is supplied for natural gas
units. Propane unit pressure is controlled by the
incoming supply regulator.
For multiple burner natural gas units, set the pressure
at 15 mbar with approximately half the total heat input
of the appliance in operation.
1.11 BURNER ADJUSTMENT
Fixed injectors are fitted and no means of adjusting
the gas rate is provided. After setting the working
pressure as above, carry out the following
adjustments tothe oven burner.
Note
An aeration shroud is located close to the injector at
the end of the oven burner. The aperture dimensions
shown in Figure 1 will achieve the desired cone
length. Do not over-aerate or the flame may
extinguish at low rates. Lock the aeration screw after
adjustment. The correct full rate cone lengths for
natural gas is 25mm. Slightly yellow flame tips are
acceptable on propane units.
X
Figure 1:
Oven Burner
'X' gap on Natural Gas models - 5mm
'X' gap on Propane Gas models - Fully Open
