Falcon F-40, Руководство оператора

Страница: 40 / 48

Maintenance and Troubleshooting F-40 Laminator Operator Manual
4-6 © GBC Pro-Tech 1998 February
Figure 4-4: Adjusting the Chain Tension
4. Using a screwdriver, apply a small amount of
downward pressure on the motor by prying against
the inside of the side frame until there is ¼" to ½"
play in the chain.
5. Tighten the mounting bolts while maintaining the
downward pressure on the motor.
6. Replace the cabinet cover and reconnect power to
the laminator.
/XEULFDWLRQ
Tools required:
•
1
/
8
" hex wrench
• High temperature grease or lithium grease
• Grease gun
To lubricate the laminator:
WARNING
WARNING
1. Remove the drive and control side cabinet covers
using the
1
/
8
" hex wrench by removing the six
screws holding each cover in place.
2. Using the grease gun, lubricate each grease fitting
(shown in Figure 4-5) with one squirt of high tem-
perature grease.
Figure 4-5: Grease Fittings
3. Lubricate the chain using a soft cloth and automo-
tive oil.
4. Replace the cabinet covers and reconnect power to
the laminator.
Do not lubricate the laminator when it is hot. You
can be burned.
Loosen Motor
Mount Bolts
1/4" to
1/2" Play
Downward
Force Tightens
Chain
Unplug the laminator and make sure it won't be
plugged back in while you are performing this
procedure. You could be severely shocked,
electrocuted, or get your fingers caught in the
drive mechanisms.
©19
94 H
CS , In
c. 8 00-7
48-0
241
Reo
rde r N
o. 1 012
-P T
Mo
ving par
ts can
crush and cut.
Do not operate with
door open.
WARNING
ACHTUNG
MISE EN GARDE
Grease
Fittings