Falcon Elan 110 Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 39 / 44

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
35
Feed the thermostat capillary clear of the oven.
Disconnect the wires from the thermostat and undo the
2 fixings that secure the control to the mounting plate.
Fit the replacement and reassemble in reverse order.
Make sure that the phial is clipped to the oven rear,
positioned centrally between the clips.
Check the operation of the thermostat.
5.2 To Remove an Oven Element Thermal Cut-out
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the cover
box. Undo the cover screws and lift clear. The cut-out
is located on the earth plate beside the oven element
connections. Disconnect the cut-out wiring. Undo the
fixings that secure the cut-out to the earth plate and
remove. Fit the replacement control and reassemble in
reverse order.
5.3 To Remove an Oven Inner Back
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Open the door and remove the shelves. Remove the
screws and washers securing the inner back to the back
of the oven
(Fig.9-6)
. Carefully lift away the inner back.
Reassemble in reverse order, making sure that the
4 screws and washers are fully tightened.
5.4 To Remove the Fan Oven Element
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the oven inner back (see 5.3). Remove the 2
screws from the top of the element and the one from
the bottom of the element inside the oven
(Fig.9-7)
.
Lift the element out carefully, disconnecting the
terminals connected to the element (noting their
positions).
If it is not possible to disconnect the leads in this way,
pull the cooker forward to gain access to the rear.
Remove the screws securing the electric cover to the
back sheet, remove the cover and disconnect the
terminals from the rear.
5.5 To Replace an Oven Fan
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the rear.
Remove the screws securing the electric cover to the
back sheet and remove the cover.
Disconnect the 3 terminals connected to the fan noting
their position. Remove the oven inner back (see 5.3).
Hold the fan blade and remove the centre nut (left-hand
thread) 2 brass washers, fan blade and circlip. Unscrew
the fan retaining nuts and washers (3 off each) and lift
the fan away from the rear of the cooker.
Fit the new fan and reassemble in reverse order.
Check the operation of the oven.
ArtNo.320-0020 Oven back fixing screws
Fig.9-6
Element fixing screws
ArtNo.321-0005 Fan oven element
Fig.9-7