Falcon Classic 110 Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 19 / 40

19
Australia
Troubleshooting
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by mistake?
Is the key symbol ( ) showing in the display? See the Clock section of the instructions for more
information on the key lock feature of the clock.
Oven temperature getting hotter as the cooker gets older
If turning the knob down has not worked or only worked for a short time then you may need a new
thermostat. This should be fitted by a service person.
Grill not cooking properly
Are you using the pan and trivet supplied with the cooker? Is the pan being used on the runners,
not the floor of the compartment? Is the grill tray pushed fully back to stop?
The oven light is not working
The bulb has probably blown. You can buy a replacement bulb (which is not covered under the
guarantee) from a good electrical shop. Ask for an Edison screw fitting 15w 230v lamp, FOR
OVENS. It must be a special bulb, heat resistant to 300 °C.
Open the oven door and remove the Handyrack (if fitted) and oven shelves.
Turn off the power supply.
Unscrew the bulb cover by turning anticlockwise. Unscrew the old bulb. Screw in the new bulb,
screw back the bulb cover. Turn on the electricity supply and check that the bulb now lights.
A crack has appeared in the Warmer plate’s surface
Disconnect the cooker immediately from the power supply and arrange for its repair. Don’t use
the cooker until after the repair. See the HELP leaflet for how to contact a service person.
Hotplate ignition or hotplate burners faulty
Is the power on? Is the clock illuminated? If not there maybe something wrong with the power
supply.
See ‘power supply’ section further on.
Are the sparker (ignition electrode) or burner slots blocked by debris?
Is the burner trim correctly located?
Are the burner caps correctly located?
See the section entitled ‘Cleaning’
Hotplate burners will not light
If only one or all the hotplate burners will not light, make sure that the parts have been replaced
correctly after wiping or removing for cleaning.
Check that there is not a problem with your gas supply. You can do this by making sure that other
gas appliances you may have are working.
Do the burners spark when you push the button? If not check the power is on - is the clock
illuminated?
Power failure
In the event of a failure in the electrical supply the hotplate may be lit using a match.