Falcon Classic 110 Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 28 / 40

28
Australia
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards along the hardboard strips and
into position. Take care not to damage the power
cable. Push the cooker close to its final position,
leaving just enough space to get behind it.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfied with the height and level raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the floor.
Screw the front roller adjuster anticlockwise to raise the
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool on the adjuster with the
handle of the tool facing the rear of the cooker, so
that the customer can use it if they wish to move
the cooker.
Replace the drawer by locating on side runners and
push in.
Fitting the stability bracket
A stability bracket and chain should be fitted when the
cooker is connected to a flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1.Place the cooker in its intended position and level the
cooker.
2.Draw a pencil line 100mm from the front edge of the
levelling feet.
3.Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4.Lower the front roller and move the cooker forward.
5.Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
floor.
6.Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height. (i.e.
from floor level to underside of the top member) and
ensure the bracket does not foul the oven burner
assembly.