Falcon Classic 110 Dual Fuel, Руководство пользователя и инструкции по установке

Страница: 34 / 40

34
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
12. To Remove or Change a Hotplate
Burner.
Remove the hotplate tray (see 2 ).
LH hotplate burners
Remove heat shield (2 screws). The burners are
mounted in 2’s on cross supports. Disconnect the
burner feed pipes at the burners. Remove the screw on
the right holding the cross support. Slide the support to
the right to release in from the left hand location. Lift
the cross support and burners clear. The burners are
fixed to the cross supports with 2 screws Remove the
appropriate burner and fit the new one. Reassemble in
reverse order. Check burner operation is satisfactory.
RH Wok burner
Disconnect the burner feed pipes at the burner. Fit the
new one and reassemble in reverse order. Check
burner operation is satisfactory.
13. To Remove Grill Door
Remove the left hand side panel (see 3). Remove the
centre cover strip (5 screws, 2 top, 2 bottom, 1 in
middle). Remove the two countersunk screws (1 each
side) securing the grill hinge arms to the front of the
grill chamber.
NOTE: The arms are spring tensioned. Carefully
remove the grill door. Retain the gaskets.
Reassemble in reverse order ensuring that the gasket
is fitted between the hinge arm and the front of the grill
chamber.
14. To Remove an Oven Door
Open oven door and remove Handyrack (where fitted)
by springing one side out of the bracket on the door
and sliding the other side free. Support the door and
remove the two screws securing the upper hinge and
packing to the cooker front. Remove the door from the
lower hinge by lifting slightly and moving outwards.
Reassemble in reverse order.
15. To Change Oven Door Outer
Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fixing screws from the door sides (two each side).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
16. To Change Oven Door Latch
Remove outer door panel (see 15). Remove screws ‘B’
holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook is
released. Proceed to the next hook and release it in a
similar way, and so on. Use force if the hooks are stiff,
as the old seal will be discarded.
When fitting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fit is
obtained. Retighten locking nut.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at
the rear of the cooker. Remove the screws securing
the cover and lift clear. Pull off all the leads to the
generator noting their positions. Slacken the two
screws holding generator to cooker and remove
generator.