Falcon Canopy hood, Инструкция по эксплуатации

Страница: 22 / 64

EN
2
2
22
Fitting the telescopic chimney
• To fit the upper section S, first expand the two side pieces slightly, fit them over the wall
brackets 1 and then close the side pieces again until tight. The top folds of the upper section
will remain connected to the wall bracket 1. Secure the upper section to wall bracket using
two of the self-threading screws provided in the bag of accessories.
• Fit the lower section I between wall bracket 1 and the wall in the same way, using the other
two self-threading screws to fix it to the base. NOTE - The upper S and lower I sections are
fixed to the wall bracket in the middle 1 through a spring and the connection is made by
pushing both sections vigorously toward the centre.
• Once the chimney stack has been installed, fit the two venting grilles into the apertures lo-
cated on either side of the lower chimney section. The grilles are marked with two arrows
and should be fitted with one arrow pointing upwards and the other toward the front. When
the hood is used in the recirculation mode ensure that the grilles are properly secured to the
recirculation spigot item F, as illustrated in fig. 10.
1
1
S
A32_07a