Falcon Canopy hood, Инструкция по эксплуатации

Страница: 19 / 64

EN
1
9
19
INSTALLATION
Installation instructions
For easy installation proceed as follows:
• Fix the wall brackets
• Fix the canopy hood
• Connect the hood to the mains supply and ensure that it works properly
• Set the hood for recirculation or evacuation
• Fix the telescopic chimney stack
Fitting the wall brackets and Splashback
Please refer to
(fig. 2)
• Draw a vertical line on the wall, from the centre of the area in which the hood is to be in-
stalled up to the ceiling. This is to ensure the correct vertical alignment of the various parts.
Positioning the lower rings
• Mark a point on the vertical line at the following distance from the cooker plate:
• Without splashback d = 892 mm min.
• With splashback
(fig. 2a) d = 242 + H mm, where H = the height in mm of the visible part
of the splashback. Because of the various different splashbacks that are available, this meas-
urement must be made on the splashback supplied with your cooker hood.
• At the point marked, draw a horizontal line parallel to the surface of the cooker top.
•
Mark
on the horizontal line the centres of the two holes to be drilled, at a distance to the left
and to the right of the vertical line of 388 mm for 90 cm models, or of 538 mm for 120 cm
models.
It will be possible to make slight adjustments using the hood adjustment screws.
Positioning wall bracket 1:
•
Place
one of the two wall brackets
1
against the wall at a distance of approximately 1 or 2
mm from the ceiling or top limit, aligning it with the vertical line.
•
Mark
on the wall the two keyholes for the wall bracket.
A32_02
1
1 1
H
X
d1
1
d1
d
242
B
H
650 min.
X
d1 d1
d=892 min.
242
Fig.2
b a