SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
32
c) Replace the element and re-assemble parts in reverse
order. Check that the oven operates satisfactorily.
27 To Remove a Grill Element
Disconnect the appliance from the electricity supply.
a) Pull the grill carriage forward and lift the grill pan away
from the carriage. Lift the grill carriage so that the front
roller is free of the side arm. Slide the carriage forward
on the rear roller until you can lift it away from the side
arm.
b) From inside grill compartment remove enamelled
front shield from grill roof, 2 screws and washers.
Remove 2 screws and washers securing the grill
element front support.
c) Remove the screws from the grill elements. Lift
elements out carefully, disconnect the leads from the
element terminals noting their position.
d) If it is not possible to disconnect the leads in this way,
turn off the gas supply. Remove the drawer – lower the
front roller. Pull the cooker forward and disconnect the
gas hose. Pull the cooker far enough forward to gain
access to the rear.
e) Remove the fixings that secure the rear cover and lift it
clear. Disconnect the terminals from the rear.
f) Fit new elements, reassemble in reverse order. Check
operation of grill.
28 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fixing screws and use the
notch and a flat bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
