21
In the Republic of Ireland:-
The installation must be carried out by a Competent
Person and installed in accordance with the current
edition of I.S.813 “Domestic Gas Installations”, the current
Building Regulations and reference should be made to
the current ETCI rules for electrical installation.
Provision of Ventilation
This appliance is not connected to a combustion
products evacuation device. Particular attention shall be
given to the relevant requirements regarding ventilation.
In the UK
The room containing the cooker should have an air
supply in accordance with BS 5440 Part 2 : 2000. All
rooms require an openable window or equivalent, while
some rooms require a permanent vent in addition to the
openable window. The cooker should not be installed
in a bedsitting room with volume less than 20m3. If it is
installed in a room of volume less than 5m3 an air vent
of effective area 100cm2 is required; if it is installed in
a room of volume between 5m3 and 10m3, an air vent
of effective area 50cm2 is required; while if the volume
exceeds 11m3, no air vent is required.
If there are other fuel burning appliances in the same
room, BS 5440 Part 2 : 2000 should be consulted to
determine the requisite air vent requirements.
In the Republic of Ireland:-
Reference should be made to the current edition of IS
813 which makes clear the conditions that must be met
to demonstrate that sufficient ventilation is available.
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner
but NOT in a room containing a bath or shower.
NOTE:
An appliance for use on LPG shall
not be installed in a room or internal
space below ground level. e.g. in a
basement.
Conversion
All models are supplied set for use on group H natural
gas. A conversion kit for Propane gas is included with the
appliance. See the instructions that are supplied with
the conversion kit. After converting the appliance please
attach the Gas Conversion sticker over the appropriate
area of the data badge, this will identify the gas type the
appliance is now set for.
This appliance is designed for domestic
cooking only. Use for any other purpose
could invalidate any warranty or liability
claim.
You will need the following equipment
to complete the cooker installation
satisfactorily
STABILITY BRACKET
If the cooker is to be supplied
with gas through a flexible
hose, a stability bracket or
chain must be fitted.
These are not supplied by with the cooker
but are available at most builders’ merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance
with the relevant
standards.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit
(only required if fitting the cooker on a stone or
concrete floor)
3. Rawlplugs
(only required if fitting the cooker on a stone or
concrete floor)
4. Steel tape measure
5. Cross head screwdriver
6. Flat head screwdriver
7. 4mm & 3mm Allen keys
8. Spirit level
9. Pencil
10. Adjustable spanner
11. Screws for fittingstability bracket
Positioning the Cooker
The diagrams show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
