1 3
ZWP 10
1
2
3
1
4
2
3
4
In/Ex
Select
1
2 3
PRIMARY
SECONDARY
x1
2
1
t<1s
x1
I N / E X
4
3
x1
2 3 4
1
x1
1
2
3
x1
1
2 3
x 1
t<1s
I N / E X
x 1
4
3
2 3 4
1
II
I
2 3 4
x3
1
3
I N / E X
Controller programming – additional functions
Function allows for such configuration of devices within
one Z-Wave network that one controlled device launch
another device, not assigned to controller's buttons of
movement. An example is launching of one servo-motor
with the use of another servo-motor equipped with a
rain sensor.
On PRIMARY controller within 1 sec. press once
IN/EX button and once SELECT button.
LEDs 1 and 2 will light up.
Within 1 0 sec. press P button on the device which
is to be controlled until LEDs on the controller
change into 3 and 4.
Within 60 sec. press P button on the device which
is to be operated (see device manual) until LEDs
on the controller change into 1 ,2,3,4.
- If a given sequence of LEDs does not occur, it is
necessary to perform procedure again.
This function allows for copying group of devices from
PRIMARY controller to SECONDARY controller and
conversely within one network.
Associating Z-Wave devices
- ASSOCIATE DEVICE
Copying group of devices
- COPY GROUP
Choose channel and within 1 ,5 sec. press IN/EX
button 3 time on the controller no. I.
LEDs 1 and 3 will light up.
Within 1 0 sec. press STOP button the group
copied, until LEDs change to 3,4
Within 1 0 sec. choose channel and perform
ASSOCIATE function on the target controller (no.
II) by pressing IN/EX and STOP button of a group
to which device is to be copied. LEDs change to
2,3,4 and on the controller no. I to 1 ,2,3,4.
- If a given sequence of LEDs does not occur, it is
necessary to perform procedure again.
All manuals and user guides at all-guides.com
