7
ZWP 10
!
1
2 3 4
1
4
x1
1
2 3
x 1
I N / E X
1
2 3
2 3 4
x1
1
2
3
Attach holder to the remote control in a location that is convenient for you.
Choose one of 5 channels on which the device is
to be assigned by pressing SELECT button.
Press IN/EX button on the back of the controller. If
LEDs 1 and 4 light up, then press one of
movement buttons of a given group until LEDs
change for 1 ,2,3.
Within 1 0 sec. press P button on the device until
the network status LED is off (see device
programming manual).
- Controller signals device correct adding by
lighting of LEDs 2,3,4
- Controller signals device incorrect adding by
blinking of LEDs 1 ,2,3 and the procedure should
be performed again from point 2.
After the above steps to ensure proper operation of
the device, wait 1 0sec.
Now controller is ready to operate.
Note! If one omits step 2, that is pressing button of
movement, the device will be added only to the
network (see INCLUDE function). Then, to be able
to operate the device, it is necessary to add it to
buttons of movement with the use of ASSOCIATE
function.
Controller programming – quick configuration
In order to add another device to the same or other
group, it is necessary to perform above procedure again.
If device has not been purchased with the controller in
a set, it should be programmed. If the network is
configured again, it is necessary to reset the controller
to factory settings (DEFAULT function) and then follow
below presented steps in appropriate time intervals.
Adding device to the controller and buttons of movement
All manuals and user guides at all-guides.com
