fakro ZWG1, Руководство пользователя

Страница: 10 / 16

3.6. Restoring default settings in the controller (DEFAULT function)
Restoring default settings of the controller leads to the following information being deleted from its
memory:
•
network, to which SECONDARY controller has been added;
•
devices in the network for PRIMARY controllers;
•
devices associated with pairs of buttons for PRIMARY and SECONDARY controllers.
After performing DEFAULT procedure the SECONDARY controller will be set as PRIMARY.
3.7. Removing SECONDARY controller from the network
Removing this controller from the network consists in restoring default settings with the use of DEFAULT
function.
4. Technical parameters
Technical parameters
Power supply CR2450, 3V DC
Working temperature (+5 O C) to (40 O C)
Working range Up to 40 [m]
Working frequency 868,42 MHz
11.11.15 NC818 10/16 ©2012, FAKRO
Figure 7: Restoring default settings in controller
1 . Within 1.5 sec. press:
- “ In/Ex ” button twice (
1
) and then
- „ FK ” button ( 2 ) once
2 . The controller is signalizing restoring default
settings – buttons flashing for 2-3 sec. as
presented in the drawing.
x2
1
2
x1
Note!!!
In the newer controller version, interrupting any procedure is possible by pressing the “IN/EX” button. In the
older version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by removing the
batteries.