fakro ZWG1, Руководство пользователя

Страница: 8 / 16

3.4. Deleting device from a pair of controller buttons (DELETE function)
This function deletes from controller's memory the device associated with a pair of buttons on a
selected channel. However, it does not remove the device form the “Z-Wave” network. This function is
accessible from PRIMARY and SECONDARY controllers. The procedure of device deleting from a pair of
controller buttons is presented in
Figure 5 .
*) Programming error can be caused by:
•
failure to press the programming button within 10 seconds from the controller signaling its readiness for
deleting the device from selected pair of buttons;
•
long distance between the controller and device.
11.11.15 NC818 8/16 ©2012, FAKRO
Figure 5: Deleting device from a pair of buttons on the controllers
4 . The controller is signalizing
successful device deleting (buttons
light up for 2-3 sec. as presented
in the drawing).
5* . Programming error – button
flashing for 2-3 sec. as presented in
the drawing.
1 . Within 1.5 sec., press:
- “ In/Ex ”( 1 ) button twice and then
- the button from this pair of buttons
which operates the device to be
removed (e.g.
2 ).
2 . The controller is signalising
readiness for device deleting (button
lights up for 10 sec. as presented in
the drawing).
3 . Press “P” button on the device
and hold it for 0.5 sec. (see Device
Programming Manual).
x1
x1
1
2
x1
x2
Note!!!
In the newer controller version, interrupting any procedure is possible by pressing the “IN/EX” button. In the
older version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by removing the
batteries.