fakro ZWG1, Руководство пользователя

Страница: 5 / 16

3.1. Adding device to network (INCLUDE function)
Adding a device to the “Z-Wave” network is possible only via “PRIMARY” controller (every
single brand new controller is set as primary controller by default). In each network, there is always only one
primary controller and any other added to it is identified as “SECONDARY”. The procedure of device adding
to the network is presented in
Figure 2.
*) Programming error can be caused by:
•
no button being pressed within 10 seconds from controller signaling its readiness for adding a new
device to the network;
•
long distance between controller and device being added;
•
the device already belonging to other network. It is necessary to use EXCLUDE function and repeat the
procedure of device adding to the network.
11.11.15 NC818 5/16 ©2012, FAKRO
Figure 2: Adding device to Z-Wave network
3 . Press “P” button on the device
and hold it for 0.5 sec. (see
Installation Manual).
4 . The controller is signalizing that the
device has been successfully added to
the network (button lights up for 2-3
sec. as presented in the drawing).
1 . Press “ In/Ex ” button once
5* . Programming error – button flashing for
2-3 sec. as presented in the drawing.
2 .
The controller is signalizing its
readiness for adding a new device to
the network (button lights up for 10
sec. as presented in the drawing).
x1
x1
Note!!!
In the newer controller version, interrupting any procedure is possible by pressing the “IN/EX” button. In the
older version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by removing the
batteries.