Operation
12
Operation
Fig. 5
Fig. 6
Fig. 7
Operation on robot vacuum cleaner
The robot vacuum cleaner uses cleaning settings to
effectively clean the whole floor:
Spiral line, fold line, straight line, and room-crossing to
ensure a full clean (
Fig. 5)
NOTICE!
The robot vacuum cleaner will take approximately 45
minutes to clean an average-sized room, about 20 m
2
,
passing over the same area several times to ensure
the whole surface is cleaned.
To start the robot, press the Start/Stop button (
21
) on
the robot panel or the button “AUTO” (
8
) on the remote
control. After starting the button (
21
) lights permanent-
ly. The robot will then start to operate, following its
cleaning patterns. If you wish a spot cleaning, press
the “SPOT” button
9
on the remote control (
Fig. 7
).
The robot works 3-5 min in the spot modus and cleans
strong dirt.
Charge indicator (
17
): Flashes during charging. It re-
mains lit when charging is complete.
1.
Remove all objects that could break or damage the
robot vacuum from the floor (e.g. lamps, bottles…).
2.
Check that the dust container (
11
) is empty and
adequately fitted and the filter (
7
) is in correct posi-
tion. See the section (“
CLEANING AND
STORAGE”).
3.
Place the virtual barrier (
4
) where you like to pre-
vent the robot entering a specific area. See the sec-
tion (“VIRTUAL BARRIER”).
4.
Start up the robot vacuum cleaner. To do so, set
the operating switch (
20
) to the
ON
position.
5.
Ensure that cleaning robot is charged.
If you want to use the robot vacuum in automatic
mode, programming its operation using the remote
control. See the section (“REMOTE CONTROL”
21
17
