Charging the battery
10
Fig. 1
Fig. 3
Fig. 4
IMPORTANT NOTICE!
All parts supplied are synchronized to each other.
The synchronization only have to be performed if re-
place or added parts, or if malfunction occur.
Coding steps
(only if replace or added parts, or malfunction
occur).
1.
Power off the robot. ON/OFF-switch (
20
)
2.
Make sure that charging station is connected
with power.
3.
Press “code”- key
3
on the dock station, no
loose, (the code key is positioned in the hole,
need to use the auxiliary tool)
4.
Power on the robot. ON/OFF-switch (
20
)
Loose the “code”-key
3
on the dock station when the
robot sounds “beep” for 2 times, finish the progress. If
you fail to hear of “beeps” of 2 times, repeat the
above steps.
Charging with charging station
Press first the “UP” button
11
and immediately af-
terwards the “ON/OFF” button
1.
The Start/Stop but-
ton
21
on the robot goes out, the LED battery charg-
ing flashes. The robot will search for the charging
station, if it is within a suitable distance, and connect
to it (may take several minutes).
Charging without the charging station
1.
Connect the charger cable directly to the connector
(
19
) of the robot.
2.
Plug the charger into the mains (
Fig. 4
).
NOTICES!
The LED indicator light on the robot´s control panel
(
17
) will flash while charging and will stop flashing
when charging is complete.
The robot cannot be started up while it is being directly
charged using the power cord.
3.
After charging, unplug the charger from the mains
and then disconnect the cable from the connector.
The appliance is ready for use.
NOTICE!
The charger heats up slightly while charging. This is
normal, unless it becomes very hot.
3
