Fagor CNC 8055, Руководство пользователя

Страница: 111 / 166

CNC 8
0
5
5
/ CNC 8
0
5
5
i
Page 51 of 106
N
EW
F
EATURES
(S
OFT
M: 9.0
X
)
COCYZ (0000000001000110)
COCYF5 (0000000000000010)
COCYF1 (0000000000000010)
The PROBE1 cycle can also be hidden by setting parameters
"PRBXMIN (P40)" through "PRBZMAX (P45)" to zero.
30.2 PLC program
The PLC program must be modified as follows in order for the machine
to work properly with this configuration:
• Stop the machine when the Z axis gets in position and the X-Y axes
are going to start moving.
• Disabled the X-Y axes when the axis to be moved is the Z axis.
• Distinguish between the execution status of programs, cycles, jog
mode and tool inspection in order to set the Z axis as a dro axis
(display only) or not.
• The PLC mark "TOOLINSP"must always be active. Otherwise,
when a STOP is generated with the PLC, it goes directly into tool
inspection mode.
The PLC program must contain a maneuver for a two-and-a-half-axis
configuration and another one for a 3-axis configuration. Switching
from one to the other must be automatic depending on the value of
"CODISET".
Bit Meaning
10 It hides the threading cycle.
14 It hides the drilling 3 cycle.
15 It hides the drilling 2 cycle.
Bit Meaning
15 It hides the 3D profile pocket cycle.
Bit Meaning
15 It hides the PROBE 1 cycle.
;
;* * * * * * * * * 2+1/2-AXIS APPLICATION * * * * * * * * *
;
() = SET TOOLINSP
= CNCRD(MPG147,R131,M1000)
;
NOT B2R131 = JMP L99 ; If not 2+1/2 axes, go to label L99.
;
() = CNCRD(OPMODA,R130,M1000)
;
NOT B0R130 ; The program is not in execution.
AND NOT B4R130 ; It is not interrupted.
AND NOT B7R130 ; And it is not in Tool Inspection.
= DRO3 ; The Z axis is a dro axis.
;
(NOT INPOSX ; The X axis is not in position.
OR NOT INPOSY) ; Or the Y axis is not in position.
AND DFD B3R130 ; Y is coming out of Tool Inspection mode.
= TG1 124 100 ; Generate /STOP.
;